Do not change angle of cutting edge or round the corner at the end of mower blade.
2.Sharpen mower blade by removing an equal amount of material from each end of the mower blade.
3.Check mower blade balance by sliding mower blade on an unthreaded bolt. If blade is balanced, it should remain in a horizontal position. If either end of mower blade moves downward, sharpen the heavy end until mower blade is balanced.
4.Install mower blade on unit (see Replacing Mower Blade).
DO NOT Sharpen to this Pattern
Sharpen to this Pattern
DISCARD if more than 1/2 in. (1.27 cm)
1. | Air Lift Erosion Area | 1 | 2 |
2. | Cutting Edge |
| |
|
|
OE0052
Figure 19
6 - 20