1 |
|
2 | 3 |
1. Cable Eye |
|
2. Flat Washer and |
|
3. Deflector Cable |
|
Figure 8 | OS1981 |
Check Function of Dual Handle Interlock
Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction clutch lever is released, then both clutches must disengage. If they do not, contact your dealer for repairs.
Check Tire Pressure
Check tire pressure and adjust to the pressure listed on tire sidewall.
Check Auger Gearcase Oil
Check oil level in auger gearcase (see Service
and Adjustments).
Check Engine Crankcase Oil
IMPORTANT: The engine is shipped with
Fill Engine Fuel Tank
Refer to Engine Manual for proper fuel type and tank capacity.
Check Function of all Controls
Ensure unit runs and performs properly. Refer
to Operation.
Run-in Attachment Belt
1.Start unit in a
2.Engage attachment clutch lever and run attachment for about 15 minutes.
3.Stop unit, wait for all moving parts to stop, and remove spark plug wire.
4.Adjust clutch according to Attachment Clutch/Brake Adjustment in Service and Adjustments.
OPERATION
WARNING: AVOID INJURY. Read and understand the entire Safety
Traction Drive Clutch - Left Hand Lever
section before proceeding.
WARNING: To avoid injury to hands and feet, always disengage clutches, shut off engine, and wait for all movement to stop before unclogging or working on snow thrower.
Keep hands and feet away from auger and impeller.
2
1
OL2701
Squeeze the Traction Drive Clutch Lever against the Handlebar
(1)to engage wheel
drive for propelling unit. Forward speed will vary according to snow depth and moisture content.
Release lever (2) to stop movement.
CONTROLS AND FEATURES
See Figure 1 for all Controls and Features locations.
Dual Handle Interlock
When Attachment Clutch and then Traction Drive Clutch are engaged, the Attachment Clutch will remain engaged (lever down) if released. To stop attachment, release Traction Drive Clutch and both clutches will disengage.
NOTE: When traveling to or from the area to be cleared, press down on the handlebars enough to raise the front of the unit slightly off the surface. Engage the traction drive clutch without engaging the attachment drive clutch.
GB - 14
