Attachment Clutch - Right Hand Lever
Squeeze Attachment
2 | Clutch Lever against |
|
Speed Selector
The Speed Selector controls the unit travel in a forward or reverse direction when positioned
handlebar (1) to engage |
| attachment. Release | |
| both clutch levers (2) to | |
| disengage power and | |
1 | apply brake to | |
attachment. | ||
| IMPORTANT: If the belt | |
OL2691 | squeals when the | |
attachment clutch lever | ||
| ||
| ||
| is engaged, the |
attachment drive may be frozen. Immediately release the attachment clutch lever and move the unit into a heated area to thaw.
Ignition Switch (120V start on engine)
Key Switch has two positions:
1.“Stop” - pulled out
2.Run - pushed in
in notch of speed.
6
5
4
3
2
1
1
2
Forward:
(6)Fastest
(1)Slow Reverse:
(1)Slow
(2)Fast
IMPORTANT: DO NOT change motion from forward to reverse with clutch engaged. Forward speed can be changed without declutching.
2NOTE: DO NOT twist key after it is inserted.
1
OS1431
OS1191
Choke Control Knob
Ignition Switch (12V start on dash panel)
21
1. | Choke Closed position: |
chokes off air to engine for | |
easier start. | |
2. | Choke Open position: |
12
3
The ignition switch is operated by a removable key. It has three positions:
1.Stop
2.Run
OS1332
allows for normal |
operation. |
IMPORTANT: Gradually open choke after engine starts.
OS0232
3.Start
Throttle
Primer Bulb
Pushing the primer bulb in adds fuel for easier engine start. Refer to Starting and Shut Off.
OS1321
1
2
3
STOP 4
OL2720
The throttle controls the engine speed. To increase or decrease the engine speed, adjust to:
1.Fast (normal or warm starts)
2.
3.Slow (cold weather starts)
4.Stop (engine is off)
Electric Starter
The electric starter will start a properly choked and cranked engine when the key is turned (12V) or starter button (120V) is pushed. Refer to Starting and
Recoil Starter Handle
When pulled, handle will turn engine over.
IMPORTANT: DO NOT let handle snap back against starter.
GB - 15