Ariens 924121 1128 manual Scraper Blade, Shear Bolts, Speed Selector Adjustment, For Replacement

NOTE: Keep housing level by adjusting runners equally.

2

1

1.Runner

2.Runner Hardware

Figure 15

SCRAPER BLADE

IMPORTANT: Damage to auger/impeller housing will result if blade wears down too far.

Scraper blade is adjustable to compensate for wear.

To adjust scraper blade:

1.Tip unit back onto handlebar, support housing and loosen nuts retaining blade.

2.Adjust runners to fully raised position (housing closest to ground).

3.Reposition scraper blade flush with runners and tighten lock nuts.

SHEAR BOLTS

IMPORTANT: Use only Ariens shear bolts for replacement. Use of any other type of shear bolt may result in severe damage to unit.

Occasionally a foreign object may enter the auger/impeller housing and jam the auger, breaking shear bolts (Figure 16) which secure the auger to the shaft. This allows auger to turn freely on the shaft preventing damage to gear drive.

For Replacement:

1.Slide auger outward against roll pin and align hole in shaft with hole in auger (holes in shaft for roll pins and shear bolts line up).

2.Drive shear bolt through hole (if shear bolt was broken this will drive remaining part from shaft).

3.Secure shear bolt with nut.

	3
1	OS0402
	2
	1. Auger
	2. Shear Bolts
	3. Roll Pin
	Figure 16

SPEED SELECTOR ADJUSTMENT

To adjust (Figure 17):

1.Place unit into service position.

2.Remove hair pin from adjustment pivot pin.

3.Pull shift rod and pin out of speed selector lever.

4.Place the speed selector in the fastest reverse speed position.

5.Pull the shift rod straight up towards the control panel as far as it will go.

6.Thread the adjustment pivot pin along the shift rod until it aligns with the mating hole on the speed selector lever. Insert the pivot pin into hole.

7.Make sure the speed selector shifts into each speed position.

8.Secure adjustment pivot pin with hairpin.

GB - 23