Ariens 924551 8524 General Lubrication, CLEAN BATTERY 924332, 505, 506, Auger Shaft, Terminals

1

2

3

2

1.Auger Gearcase - Cast Iron

2.Oil Fill and Drain Plug

3.Auger Gearcase - Aluminum

Figure 10

GENERAL LUBRICATION

IMPORTANT: Wipe each fitting clean before and after lubrication.

IMPORTANT: DO NOT allow grease or oil to get on friction disc, friction plate or belts.

NOTE: Apply Stens Mix Hi-Temp Grease or equivalent to the lubrication fittings. See Service Parts.

Sno-Thro should be lubricated (Figure 11) at beginning of season or every 25 operating hours.

Auger Shaft

NOTE: To grease auger shaft, remove shear bolt nuts, and shear bolts. Turn auger on shaft while applying grease at zerk fittings. Replace shear bolt per instructions in Service and Adjustments.

2 8

6

5

4

1 1 1 1

7

	3
1. Auger and Shaft	5. Shift Lever Arm
2. Discharge Chute	6. Pinion Chain
3. Sprocket/Pinion	7. Hex Shaft	Grease Oil
Assembly	8. Shift Link
4. Axle Shaft

OS0641

OS0741

Figure 11

CLEAN BATTERY (924332, 505, 506, 508)

WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.

IMPORTANT: Battery is maintenance free. Do not tamper with or attempt to open battery. See Service and Adjustments for charging procedures.

Terminals

Keep battery and its terminals clean.

IMPORTANT: Remove battery from unit before cleaning.

Remove corrosion from battery terminals and cable connections with a wire brush, then wash with a weak baking soda solution.

After cleaning, apply a thin coat of grease or petroleum jelly to terminals and cable ends to retard corrosion.

GB - 21