Use the handlebar hardware locations on the side of the unit frame to determine which hole gets used to secure the chute rod to the control assembly.
44
1
1
2 | 2 |
33
1.Chute Control Assembly
2.Hair Pin
3.Chute Rod
4.Handlebar Mounting Hardware
Figure 7 | OS7156 |
6.Insert the chute lock cable fitting into the bracket on the chute pedestal, and then connect the chute lock cable to the lock teeth by fitting the cable ball end into the slot on the lock teeth.
NOTE: Press down on lock teeth with your finger to align the cable ball end with the slot.
|
|
|
|
|
|
|
|
|
|
|
| OS7270 |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
| |
Figure 8 |
| |||||||||||
|
| |||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
7. Replace the gear cover removed in step 1.
IMPORTANT: Rotate the discharge chute to the left when tightening the pedestal hardware to ensure clearance between the discharge chute and the belt cover.
8.Tighten pedestal hardware to
9.Make sure the discharge chute rotates left and right when you push the discharge chute control lever left and right.
Deflector RemoteNOTE: Connect the cable end to the cable anchor on the discharge deflector before clipping the cable to the cable bracket on the discharge chute.
1.Route deflector remote cable along the left side of the chute pedestal.
2.Insert the barrel on the cable end into the bracket on left side of chute deflector (Figure 9).
3.Hold seal out of the way while routing the cable through the bracket on the left side of the discharge chute, and then push the cable fitting into the bracket.
4.Push the seal securely over the end of the cable fitting to prevent water from entering the cable.
5.Check deflector travel. Adjust nut on cable end under handlebar to obtain full travel, if necessary. (See Deflector Remote on page 24.)
3
2
1
3
5 
4 
1.Cable Anchor
2.Cable End
3.Deflector Cable
4.Cable Fitting
5.Cable Bracket
Figure 9 | OS7070 |
|
GB - 11