5.Loosen the top jam nut 1 – 3 turns.

6.Tighten the bottom jam nut.

7.Re-install bottom cover.

8.Check function of remote wheel lock. If wheel lock does not function properly, take unit to Dealer for repairs.

Finger tighten top jam nut, then loosen top jam nut 1 – 3 turns.

3

1

2

No Slack

1.Top Jam Nut

2.Bottom Jam Nut

3.Cable Adjuster

Figure 24

OS7170

DEFLECTOR REMOTE

Deflector must stay in selected position while throwing snow.

If deflector does not stay in set position:

1.Tighten nut beneath control panel to increase pressure on deflector control (Figure 25).

If deflector does not follow full range of travel:

1.Push deflector remote all the way forward.

2.Loosen adjusting nuts on cable support bracket underneath the dash panel (Figure 25).

3.To adjust the deflector lower:

Slide cable down. Tighten bottom nut.

4.To adjust deflector higher: Slide cable up. Tighten top nut.

5.Check travel and repeat adjustment as necessary.

Tighten nut.

12

1.Adjusting Nuts

2.Cable Support Bracket

Figure 25

OS7175

DISCHARGE CHUTE

If chute does not stay in position while throwing snow or if chute does not rotate freely, adjust the cable under the control panel so the chute lock fingers engage or disengage the locking gear.

If chute does not stay in position:

Loosen the cable by loosening the lower adjustment nut, and then tightening the upper adjustment nut against the bracket (Figure 26).

Tighten upper adjustment nut.

Loosen lower adjustment nut.

Figure 26

OS7180

GB - 24