WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.
WARNING: To avoid injury to hands and feet, always disengage clutches, shut off engine, and wait for all movement to stop before unclogging or working on snow thrower.
Keep hands and feet away from auger and impeller.
CONTROLS AND FEATURESSee Figure 10 for all Controls and Features locations.
Dual Handle InterlockWhen Attachment Clutch and then Traction Drive Clutch are engaged, the Attachment Clutch will remain engaged (lever down) if released. To stop attachment, release Traction Drive Clutch and both clutches will disengage.
Traction Drive Clutch - Left Hand Lever
| Squeeze the Traction Drive Clutch |
2 | Lever against the Handlebar (1) to |
| engage wheel drive for propelling |
2Key Switch has two positions: 1. “Stop” - pulled out
22. "Run" - pushed in
1NOTE: DO NOT twist key after it is inserted.
OS1431
Ignition Switch (12V start on dash panel)1 | 2 | The ignition switch is operated by a |
| removable key. It has three positions: | |
|
| |
| 3 | 1.Stop |
|
| 2.Run |
OS0232 3.Start
Primer BulbPushing the primer bulb in adds fuel for easier engine start. Refer to Starting and Shut Off on page 17.
OS1321
Speed SelectorPosition the Speed Selector in the appropriate speed notch to control forward and reverse travel.
| unit. Forward speed will vary |
| according to snow depth and |
1 | moisture content. |
| |
| OL2701 Release lever (2) to stop movement. |
NOTE: When traveling to or from the
area to be cleared, press down on the handlebars enough to raise the front of the unit slightly off the surface. Engage the traction drive clutch without engaging the attachment drive clutch.
Attachment Clutch - Right Hand Lever6
1
1
Forward:
(6)Fastest
(1)Slowest
Reverse:
(1)Slow
(2)Fast
IMPORTANT: DO NOT change motion from forward to reverse with clutch2
Squeeze Attachment Clutch Lever against handlebar (1) to engage attachment. Release both clutch
2
OS1192
engaged. Forward speed can be changed without declutching.
levers (2) to disengage power and apply brake to attachment.
1 | IMPORTANT: If the belt squeals |
| when the attachment clutch lever is |
OL2691 | engaged, the impeller may be frozen |
| in the auger housing. Immediately |
release the attachment clutch lever and move the unit into a heated area to thaw.
NOTE: If belt squeals when impeller turns freely, see Attachment Drive Belt Replacement on page 27.
21
OS1332
1.Choke Closed position: chokes off air to engine for easier start.
2.Choke Open position: allows for normal operation.
IMPORTANT: Gradually open choke after engine starts.
GB - 14