If remote wheel lock does not lock or unlock properly, adjust or repair before operation (see REMOTE WHEEL LOCK (926002, 003, 102, 103, 302, 303, 304) on page 23).
Axle Lock Pin (Figure 13) (926001, 101, 504, 505)
Use the axle lock pin to lock or unlock the right or left wheel. Lock both wheels to increase traction; unlock one wheel to allow for easier turning of the unit.
NOTE: Unit will not drive with both wheels unlocked.
Wheel Unlocked
Wheel Locked | Axle Lock Pin |
|
Figure 13
Scraper Blade
The scraper blade allows the back of the housing to keep better contact with the surface being cleared. It also prevents damage to the housing from normal wear.
IMPORTANT: DO NOT allow Scraper Blade to wear too far or Auger/Impeller housing will become damaged.
Runners
The runners control the distance between the scraper blade and the ground. Adjust runners equally to keep blade level with the ground. Refer to
Drift Cutters (Figure 14)
Drift cutters break up snow drifts that are taller than the auger housing and direct the snow into the auger. Store the drift cutters on the auger housing when not in use. Install them as shown below so they are taller than the snow to be cleared.
1
2
1. Stored Position
2. Operating Position
Figure 14 | OS7110 |
FILLING FUEL TANK
WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.
Fuel Shut-Off Valve
IMPORTANT: The fuel
The fuel
•Closed Position: Use this position to service, transport, or store the unit.
•Open Position: Use this position to run the unit.
CLOSEDOPEN
Figure 15 |
| OS7115 |
|
To add fuel to fuel tank:
1.ALWAYS place unit in open or
2.Stop engine and allow to cool.
3.Clean Fuel Cap and surrounding area to prevent dirt from entering Fuel Tank.
4.Remove Cap.
GB - 16