Asus 810 2 I/O Voltage Setting VIO, Onboard Audio Setting AUDIO CODEC on audio model only

3.HARDWARE SETUP

2)I/O Voltage Setting (VIO)

This jumper allows you to select the voltage supplied to the DRAM, chipset, PCI, and the CPU’s I/O buffer. The default voltage should be used unless your processor setting requires a higher voltage.

Setting VIO

Normal	[1-2] (default)
3.66V	[2-3]

CUW

VIO

1	2	3	1	2	3
Normal			Add 0.1 Volt
(Default)

CUW Input/Output Voltage Setting

WARNING! Using a higher voltage may help when overclocking but may result in the shortening of your computer component’s life. It is strongly recommended that you leave this setting on its default.

3)Onboard Audio Setting (AUDIO CODEC) on audio model only

The onboard audio CODEC may be enabled or disabled using all of these jump- ers. Disable the onboard audio CODEC if you are using an ISA or PCI audio card on any of the expansion slots or a primary AMR on the AMR slot (see AMR Slot later in this section). If using an ISA or PCI audio expansion card, Onboard AC’97 Audio Controller in 4.4.2 I/O Device Configuration must also be disabled.

Setting	AUDIO CODEC
Enable	[1-2] [1-2]	[1-2]	[1-2] (default)
Disable	[2-3] [2-3]	[2-3]	[2-3]

.3 SETUPH/W

Motherboard Settings

Enable

(Default)

SPK AUD EN1

	3
	2
CUW	1
	ADN#	AUD EN2

Disable

SPK	AUD EN1
3
2
1
ADN#	AUD EN2

CUW Audio Codec Setting

ASUS CUW User’s Manual 19