Asus 810 Chassis Intrusion Lead 2-pin CHA, ATX Power Supply Connector 20-pin block ATXPWR

3.HARDWARE SETUP

23)Chassis Intrusion Lead (2-pin CHA)

This lead is for a chassis designed for chassis intrusion detection. After-market toggle switches may also be installed to the chassis panel or on any removable components. Two wires should be available from the chassis to connect to this lead. When any chassis component is removed, the circuit should open and the motherboard will record a chassis intrusion event. If the chassis intrusion con- nector is not used, a jumper cap must be placed over the pins to close the circuit.

CHA

CUW

CUW Chassis Open Alarm Lead

24)ATX Power Supply Connector (20-pin block ATXPWR)

This connector connects to an ATX power supply. The plug from the power sup- ply will only insert in one orientation because of the different hole sizes. Find the proper orientation and push down firmly making sure that the pins are aligned.

IMPORTANT: Make sure that your ATX power supply can supply at least 10mA on the +5-volt standby lead (+5VSB). You may experience difficulty in power- ing ON your system if your power supply cannot support the load. For Wake- On-LAN support, your ATX power supply must supply at least 720mA +5VSB.

.3 SETUPH/W

Connectors

ASUS CUW User’s Manual 41