Asus 810 Wake-On-LAN Connector 3-pin WOLCON, Wake-On-Ring Connector 2-pin WOR, Hardware Setup

3.HARDWARE SETUP

12)Wake-On-LAN Connector (3-pin WOL_CON)

This connector connects to a LAN card with a Wake-On-LAN output, such as the ASUS PCI-L101 Ethernet card (not required for onboard LAN model). The connector powers up the system when a wakeup packet or signal is received through the LAN card.

IMPORTANT: This feature requires that Wake On LAN is set to Enabled (see

4.5.1Power Up Control) and that your system has an ATX power supply with at least 720mA +5V standby power.

CUW

CUW Wake-On-LAN Connector

IMPORTANT: Requires an ATX power supply with at least 720mA +5 volt standby power

WOL_CON

Ground

PME +5 Volt Standby

.3 SETUPH/W

Connectors

13)Wake-On-Ring Connector (2-pin WOR)

This connector connects to internal modem cards with a Wake-On-Ring output. The connector powers up the system when a ringup packet or signal is received through the internal modem card. NOTE: For external modems, Wake-On-Ring is detected through the COM port.

IMPORTANT: This feature requires that PWR Up On Modem Act is set to Enabled (see 4.5.1 Power Up Control) and that your system has an ATX power supply with at least 720mA +5V standby power.

	1	2
CUW	Ground	RI#
	WOR

CUW Wake-On-Ring Connector

ASUS CUW User’s Manual 35