4.2 Install Hot-swap HDD

Install an IDE Drive

1.Connect the IDE cable to the IDE connector at the back of the drive.

2.Connect the power cable to the power connector at the back of the drive.

IDE Cable Power Cable

3.Carefully place the drive into the tray until it fits in place.

4.Secure the drive with four screws (two on each side).

5.Align the tray cover to the rails at the back of the tray, then slide the cover forward until the metal latch clicks in place.

6.Insert the hot-swap drive tray into the bay until it is flushed to the front panel.

7.Lock the hot-swap drive tray with the security key to prevent unauthorized access.

8.Do steps 1 to 7 to install the other hot-swap drive.

Installed Hot-Swap Drive Trays

38

Chapter 4: Hardware Options