4.5 CD-ROM Drive

Re-install the CD-ROM Drive

1.Align the CD-ROM drive to its bay and carefully push it inward until it is flushed to the front panel.

2.Secure the drive with the screws that you removed earlier (two on each side).

NOTE: Align the front screw with the hole labeled 1.

3.Connect the IDE cable to the IDE connector at the back of the drive, matching the red pin stripe on the cable with Pin1 on the IDE connector.

4.Connect the power cable labeled P2 to the power connector at the back of the drive.

IDE Cable

Red Stripe to Pin 1

CD-ROM

Screws

Align with Hole 1

Power Cable (P2)

42

Chapter 4: Hardware Options