Asus P5SD2-FM manual IDE connectors 40-1 pin PRIIDE, Secide

3.IDE connectors (40-1 pin PRI_IDE, SEC_IDE)

These connectors are for a Ultra DMA 100/66 signal cable. The Ultra DMA 100/ 66 signal cable has three connectors: a blue connector for the primary IDE connector on the motherboard, a black connector for an Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive), and a gray connector for an Ultra DMA 100/66 IDE master device (hard disk drive). If you install two hard disk drives, you must configure the second drive as a slave device by setting its jumper accordingly. Refer to the hard disk documentation for the jumper settings.

• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable.

•Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

FM-P5SD2

r

P5SD2-FM IDE Connectors

SEC_IDE

NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.

IDE_PRI

PIN 1

ASUS P5SD2-FM 1-27