RX3141 User’s Manual | Chapter 5 Router Connection Setup |
| Figure 5.5. WAN – PPPoE0 Settings | Figure 5.6. WAN – PPPoE1 Settings |
3.Configure firewall outbound ACL rules to forward the designated traffic to each intended PPPoE session. Please refer to section 9.5 “Configuring Outbound ACL Rules” for instructions on setting up ACL rules. Figure 5.7 and Figure 5.8 show the settings for the two outbound ACL rules – one specify the destination network using the network address and subnet mask and the other using the domain name. Only one of the two ACL rules is needed. However, if you intend to use IP address and the domain name to access the myService network, you’ll need to configure both rules.
Figure 5.7. WAN – First ACL Rule Settings (using | Figure 5.8. WAN – Second ACL Rule Settings |
network address/subnet mask) for Forwarding | (using domain name) for Forwarding Packets to |
| Packets to PPPOE1 Session | PPPOE1 Session |
4.Verify that you have all the rules properly configured as indicated in the “Existing Outbound ACL” table as shown in Figure 5.9. Note that the third rule is the default outbound ACL rule that allows all the outbound traffic to go through the firewall. You’ll have to configure this rule (see the default outbound ACL settings in Figure 5.10) if you had deleted. The third rule is used to forward all the outbound traffic to PPPoE0 session except those intended for PPPoE1 session.
29