BIOS SPECIFICATION
6-9
LAN Controller Dynamic D800~D8FF IRQ16 FE8FEC00~
FE8FECFF
Wireless (802.11abg) Static IRQ17 FDFFF000~
FDFFFFFF
Ricoh MS Dynamic IRQ19 FE8FF000~
FE8FF0FF
Ricoh SD Dynamic IRQ19 FE8FF400~
FE8FF4FF
Note: The resources of dynamic devices will be changed if users change the settings. The IRQ 9 is
reserved for SCI of ACPI O.S.
4.6 POWER MANAGEMENT
In addition to C1, C2/C2E, C3 and C4/C4E states at system full on state, the S62F platform must also
support suspend states described in next two sections.
4.6.1 ACPI-Enabled Environment
Table 4-5 Power Management in ACPI mode
Power State Entry Event Source Wake Up Event Sour c e
S3 z Standby Timer Time out
z Select “Standby” in O.S.
z LID switch
z Power button
z PME (onboard L AN, Car d Bu s card)
z High Definition Audio (modem)
z USB (USB devices)
z RTC Alarm
z Internal keystroke
z Power button
S4 z Standby Timer time out
z Select “Hibernate” in O.S.
z LID switch
z Power button
z PME (onboard L AN, AC Only)
z RTC Alarm
z Power button
Soft Off z Select “Shut Down” in O.S.
z LID switch
z Power button
z RTC Alarm
z Power button
z PME (onboard L AN, AC Only)
Note : LID won’t trigger a wake up.
4.6.2 ACPI 2.0
S62F BIOS is ACPI 2.0 compliance. It supports Windows XP Native Processor Performance Control.
In Windows XP, the processor performance control policy is linked to the Power Scheme setting in
the standard control panel power options applet. No additional UI is employed to set the policy.
Windows XP defines four control policies for processor performance control:
Constant Always runs at lowest performance state
Adaptive Performance state chosen based on CPU demand
Degrade Starts at lowest performance state, then uses linear performance reduction (stop
clock throttling) as battery discharges
None Always runs at highest performance state
The following table shows the relationship between the Power Scheme selected and the control
policy used.
Table 4-6 Power Scheme Table