Drivers Display

Setup S/W .3

3. Software Setup

Windows NT 4.0Method 1: Display Property Page

WARNING! Before installing the display driver in Windows NT 4.0, make sure that

you have installed Windows NT 4.0 Service Pack 3 or later, to take full advantage of the AGP features of your card. (You may download service packs at

http://www.microsoft.com/ntworkstation/downloads.)

NOTE: The following steps assume your CD-ROM drive letter is D.

1.Start Windows NT, switch display properties to VGA mode (16 colors, 640 x 480 pixels), then restart your computer to make the change.

2.After your computer restarts, right-click the desktop and click Properties.

3.Click the Settings tab.

4.Select Change Display Type.

5.Select Adapter Type and click Change.

6.Click Have Disk.

7.Insert the CD installation disc.

8.Type D:\NT40 or click Browse to select the path of the display driver for Win- dows NT. Click OK.

9.Select ASUS V7100 and then click OK.

10.Windows NT will once again prompt for confirmation. All appropriate files are then copied to the hard disk. When all files are copied, go back to the Display Properties box by clicking Close. Click Apply.

11.The System Settings Change dialog box is displayed. Click Yes to restart Windows.

12.Windows NT will restart with the default settings. The Display applet will ap- pear to allow for mode selection.

24

ASUS V7100 Series User’s Manual