Changing Channels, Headset Jack | AT&T 900 MHz specs

TELEPHONE OPERATION

AT THE HANDSET

Changing Channels

This cordless telephone has an advanced AutoSelect feature that minimizes the chance of interference. When the phone is looking for a clear channel, the screen displays SEARCHING.... If it is unable to locate a clear channel, the screen displays TRY AGAIN. Hang up and try your call again.

In the unlikely event that you notice noise or interference while using the handset:

1Press L.

2If the interference does not clear, move closer to the base and press Lagain until you find a clear channel (your call will not be interrupted).

NOTE: You must be within range of the base to change channels (see the OPERATING RANGE section of this manual).

Headset Jack

You can use this telephone hands-free when you install an AT&T 2.5 mm headset (purchased separately).

1Plug the headset into the jack located on the left side of the handset. Do not force the connection, but make sure the plug fits securely.

2Follow the instructions under “Make,Answer, or End a Call” on page 19.

3If you wish, attach the belt clip (see page 5 in the INSTALLATION section of this manual).

NOTE: The earpiece and microphone on the handset are disabled when the headset is plugged in.

22

Image 23

AT&T 900 MHz user manual Changing Channels, Headset Jack

Contents

USER’S Manual Advanced American Telephones. All rights reserved Contents About Home and Local Area Codes About Caller ID with Call Waiting Before You Install Installation Install the handset battery Table/Desk and Wall Installation Connect the telephone line cord Softkeys Feature SetupMessage Window Display for Feature Setup Handset Ringer Telephone Feature SetupDial Mode Handset Ringer Off / Battery Save Call List Options Caller ID Feature SetupProgram Home and Local Area Codes Caller ID with Call Waiting Answering System Feature Setup Audible Message Alert Select Your AnnouncementRing Select / Toll Saver Change Priority Calling Code Change Remote Access CodePriority Call Signal Record Your Announcement from the Base Review Feature Settings Set the Clock Delete an Announcement Caller Specific Outgoing Announcement Feature Setup Talking Caller ID Feature Setup Announcements Outgoing Local Review ADD Enter Number Done Menu Call ID DIR Directory MEM ANS SYS Delete Done Preview a Handset VolumeMake Answer, or End a Call Flash Mute Telephone OperationRedial Temporary Tone Record a Phone Conversation HoldIntercom Headset Jack Changing Channels AT the Base Speaker Base Ringer Volume Handset Locator Page/Intercom Store a Number in Memory Telephone MEMORY/DIRECTORY Replace a Stored Number Store a Pause in a Memory NumberStore a Name with a Memory Number View Memory Numbers Store a Number and Name from Call History Edit Memory Numbers Delete Memory Numbers Dial a Memory Number from the Base Priority Ring NumbersDial a Memory Number from the Handset Announcement Play/Silent Audible IndicatorsAbout Mailboxes Record a Memo Answering CallsCall Screening/Intercept Announcement Bypass Function Button Listen To, Save & Delete Messages CL ↔ AO Message Window Display From a Touch Tone Phone Call ScreeningConnect with the Answering System From the Cordless Handset Function Command Remote Access Commands End remote access call Voice Help Menu Audible Signals Memory Match Call WaitingIncoming Call History Display Dial Review Call History Delete a Specific Call Record Caller ID OperationDelete Call Records from Call History Delete All Call Records Caller ID Display Messages Operating Range Batteries Battery LifeCharge the Handset Battery Pack Batteries Replace the Handset Battery Pack To re-initialize the handset and base Case of DifficultyIf the phone does not work at all, check these items first If you have no dial tone If the caller’s name or phone number is not displayed If you hear noise or interference when using the phoneIf the phone does not ring when you receive a call If you have difficulty hearing messages If speakerphone conversation sounds distortedIf messages are incomplete If your outgoing announcement isn’t clear If CL appears in the Message Window Answering System Remote Commands Remote Command Press