Getting started
Battery installation & charging
Install the battery as shown on the next page. Once you have installed the battery, the screen indicates the battery status (see table below). If necessary, place the handset in the telephone base or charger to charge the battery. For best performance, keep the handset in the charger when not in use. The battery is fully charged after 16 hours of continuous charging. See the table on page 72 for battery operating times.
If the screen is blank, you need to charge the handset without interruption for at least 30 minutes to give the handset enough charge to use the telephone for a short time. The screen shows LOW BATTERY and the backlight is off until you have charged the battery without interruption for at least one hour. The following table summarizes the battery charge indicators and actions
to take.
Battery indicators | Battery status | Action | ||
The screen is blank or | Battery has very little or | Charge without | ||
shows Place in charger. | no charge. The handset | interruption until the | ||
|
|
| cannot be used. | screen shows LOW |
|
|
|
| BATTERY (at least 30 |
|
|
|
| minutes). |
|
|
|
|
|
The screen shows LOW | Battery has enough | Charge without | ||
BATTERY and |
| flashes. | charge to be used for a | interruption until the |
|
|
| short time. | screen shows HANDSET |
|
|
| ||
|
|
|
| X (at least one hour). |
The screen shows | Battery is charged. | To keep the battery | ||
HANDSET X. |
| charged, place it in | ||
|
|
|
| the telephone base or |
|
|
|
| charger when not |
|
|
|
| in use. |
|
|
|
|
|
NOTE: If you are on a phone call in low battery mode, you hear four short beeps every minute.
