CM1164 User Manual

OSD Operation and Menu

There are three ways to cycle through the OSD menu, go to submenus, change/ adjust the options and make a selection, as follows:

ŠFront panel pushbuttons. Use the Function (Fn1~Fn4), Select and OSD pushbuttons located on the CM1164’s front panel. The Fn1~Fn4 buttons are positioned to correspond to the up / down / left / right directions.

See Front View, page 6.

You can configure the KVM focus using the front panel pushbuttons, and save them using the Fn Key page (see page 47) for later use. See Manual Switching, page 17 for instructions on how to switch KVM, audio and USB focus between ports. See FN Keys, page 23 for information on how the Fn buttons/menu options work. See page 47 for details on storing and restoring function settings using the OSD.

ŠIR remote control. See IR Remote Control, page 8.

ŠConsole mouse. If the Hardware Cursor (see page 40) is enabled, use the mouse to navigate the OSD menu. See Hardware Cursor Mode, page 40.

The OSD menu options are shown in the table below. The highlighted texts indicate the CM1164’s default setting.

Menu Page

 

Sub-Menu Page(s)

 

 

 

 

Login Page

 

 

 

 

 

 

Port

Select which computer/video source device is displayed by selecting the port to

Selection

which it is connected.

 

 

 

 

 

 

Mode

Quad

 

See Quad, page 37.

 

 

 

 

 

PiP Dual

 

See Picture in Picture (Dual / Triple /

 

 

 

Quad), page 37.

 

PiP Triple

 

 

 

 

 

 

 

 

 

PiP Quad

 

 

 

 

 

 

 

Disable Channel

 

Port 1~4

 

 

 

 

 

Quadview Resolution

 

See Quadview Resolution, page 38.

 

 

 

DCC

Select which video source in the DCC installation is shown on the display.

 

 

 

 

34