CM1164 User Manual

(Continued from previous page.)

To configure the PiP (Dual / Triple / Quad) screens, do the following steps:

1.Check the port number that corresponds to each channel.

2.Alpha. Checking this option affects the amount of transparency for the port’s display, enabling you to see through it.

3.PbP. In Picture in Picture mode, Channel 1 takes up the whole screen while the rest of the channels are placed on the right side of the display, partially blocking Channel 1.

In order to view Channel 1 in full, check PbP (Picture by Picture). This shows Channel 1 in full, although in a smaller resolution that allows all the channels to fit into the display.

4.Channel Size. Use the minus (-) and plus (+) signs to select a channel’s screen size. You can choose a value from 1 to 3 (maximum size).

Disable Channel

Check the port number that you do not want to show on screen. The corresponding channel of that port number is hidden from view.

Quadview Resolution

In Quad Mode, the maximum video resolution used by default is the resolution of the source device assigned to Channel A. The sizes of all the channels are resized to fit this resolution, which may cause poor video quality if the resolution is smaller than that of the source device.

To change the maximum video resolution, use this screen to select the video resolution that best fits the display. Options are as follows:

Š1280 x 720

Š1280 x 960

Š1280 x 1024

Š1360 x 768

Š1440 x 900

Š1600 x 1200

Š1680 x 1050

Š1920 x 1200

Š1920 x 1080

38