2. Installation

Single Stage Installation

Refer to the installation diagrams on the following page as you perform the following steps. The numbers in the diagrams correspond to the steps:

1.Plug your USB keyboard, USB mouse, monitor, microphone and speakers into the Console Ports located on the unit's rear panel.

2.Using a KVM cable set (requires a separate purchase, see Cables, page 3), plug the custom SPHD connector into any available KVM Port on the switch, and plug the accompanying microphone and speaker cables into the KVM Port's microphone and speaker jacks.

Note: Be sure that all the plugs are in the same KVM Port sockets (all in Port 1, all in Port 2, etc.).

3.At the other end of the cable:

a)For a USB connection (see USB Cable Connection, page 13), plug the USB, video, microphone and speaker cables into their respective ports on the computer.

b)For a PS/2 connection (see PS/2 Cable Connection, page 13), plug the keyboard, mouse, video, microphone and speaker cables into their respective ports on the computer.

4.Plug the power adapter cable into the switch's Power Jack, then plug the power adapter into an AC power source.

5.Repeat steps 2 - 4 for any other computers you are connecting up.

This completes the single stage installation, and you can turn on the power to the computers.

Note: The CS-1754 / CS-1758 initially links to the first computer you turn on.

11