Installation

Before you Begin

1.Make sure that the power to each of the devices you will be connecting up has been turned off. You must unplug the power cords of any computers that have the Keyboard Power On function.

2.Make sure that all devices on the installation are properly grounded.

Single Station Installation

In a Single Stage installation, there are no additional Master View’s cascaded down from the first unit. To set up a single stage installation do the following:

1.Plug your keyboard, mouse, and monitor into the unit’s Console Ports.

2.Use KVM cable sets (as described in the Cables section on p. 3), to connect any available CS-88A CPU Port to the Keyboard, Video and Mouse ports of the computer you are installing.

3.If you choose to use external power, plug the power adapter cable into the Master View’s Power Jack, then plug the adapter into an AC power source.

Note: The switch is designed for non-powered operation in a single stage installation by taking its power from the computers via the KVM cables. If a computer, only supplies 3.3V of power for the keyboard and mouse instead of 5V (as in the case of Notebooks, for example), the unit will not receive enough power, and you will need to use the external power adapter.

4.Turn on the power to the computers.

Note: If you choose to use external power, the Master View unit must be plugged in and receiving power prior to turning on the power to the computers.

CS-9134 / CS-9138 User Manual

7

2005-12-21