OSD Factory Default Settings
The factory default settings are as follows:
Setting | Default |
Display Duration | Always On |
|
|
Display Mode | The Port Number plus the Port Name |
|
|
Scan Duration | 3 Seconds |
OSD Security
In order to prevent unauthorized access to the systems, the OSD provides a password security feature. If a password has been set, the OSD will request that the user specify it before allowing entry. To set a password:
1.Press [F6] to bring up the setup configuration menu.
2.Move the highlight bar to Set Password, then press [Enter].
3.Key in the new password, then press [Enter].
The password may be up to 8 characters long, and can consist of any combination of letters and numbers (A - Z, 0 - 9).
4.Key in the new password again, in order to confirm that it is correct, then press [Enter].
If the two entries match, the new password is accepted and the screen displays the following message:
SET PASSWORD OK
If the entries do not match, the screen displays the message:
PASSWORD NOT MATCH
in which case you must start again from the beginning.
Note: To modify or delete a previous password, access the Password function as in Steps 1 and 2, then use the backspace or delete key to erase the individual letters or numbers.
24 |