Chapter 1. Introduction
LCD Module1
|
| 4 |
| 2 |
|
|
| 3 |
No. | Component | Description |
1 | LCD Display | To access the LCD monitor, slide the LCD module out and flip |
|
| up the cover. See Opening the Console, page 21, for details |
|
| on sliding the LCD module out. |
2 | LCD Controls | These buttons control the position and picture settings of the |
|
| LCD display. See LCD OSD Configuration, page 27, for |
|
| details. |
3 | LCD On/Off | Push this button to turn the LCD monitor on and off. The |
| Button | button lights when the LCD monitor is off to indicate that only |
|
| the monitor is off – not the KVM switch itself.) |
4 | Firmware | Firmware Upgrade Port: The Firmware Upgrade Cable that |
| Upgrade Section | transfers the firmware upgrade data from the administrator's |
|
| computer to the KL1508A / KL1516A plugs into this |
|
| connector. |
Firmware Upgrade Switch: During normal operation this switch should be in the NORMAL position. (See The Firmware Upgrade Utility, page 59 for firmware upgrading details.)
9