WebShare 144WN

3.2.2 LAN and WAN Port Addresses

The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown below.

Porta LAN

 

 

 

Porta WAN

 

 

 

 

 

 

 

IP address

192.168.1.254

 

 

Mode=Routing

 

Subnet Mask

255.255.255.0

 

 

Encapsulation=PPPoA

 

DHCP server function

Enabled

 

 

Multiplex=VC

 

 

 

 

 

VPI=8

 

IP addresses for

100 IP addresses

 

 

 

distribution to PCs

continuing from

 

 

VCI=35

 

 

192.168.1.100 through

 

 

 

 

 

 

 

 

 

 

192.168.1.199

 

 

 

 

3.3 Reset of WebShare Wireless N ADSL2+ Router

If you forget the password, you can restore router with Default Factory Setting usingReset”“button in the rear of the produ be sure that led SYSReset”isbuttonlit, thenfor 10presse SYS will turn off and it will blink; it will be lit when firmware with Factory Default Setting will be loaded. Now you can enter on WebShare Wireless N ADSL2+ Router with passwordatlantis”. “

3.4 Informations from the ISP

Before configuring this device, you have to check with your ISP (Internet Service Provider) what kind of service is provided such as PPPoE, PPPoA, RFC1483, or IPoA.

Gather the information as illustrated in the following table and keep it for reference.

PPPoE

PPPoA

RFC1483 BridgedRFC1483 Routed

VPI/VCI, VC-based/LLC-based multiplexing, Username, Password, Service Name, and Domain Name System (DNS) IP address (it can be automatically assigned by your ISP when you connect or be set manually).

VPI/VCI, VC-based/LLC-based multiplexing, Username, Password, and Domain Name System (DNS) IP address (it can be automatically assigned by your ISP when you connect or be set manually).

VPI/VCI, VC-based/LLC-based multiplexing to use Bridged Mode.

VPI/VCI, VC-based/LLC-based multiplexing, IP address, Subnet mask, Gateway address, and Domain Name System (DNS) IP address (it is fixed IP address).

A02-RA144-W300N

Pag. 22