WebShare 144WN

 

 

1

Check the Ethernet LEDs on the front panel. A LAN LED should

 

be on if the port is connected to a computer or hub. If the

 

10M/100M LEDs on the front panel are both off, refer to Section

 

A.1.2.

2

Make sure that the IP address and the subnet mask of the ADSL

 

Router and your computer(s) are on the same subnet.

A.6 WAN Interface

Initialization of the ADSL connection failed.

STEPS

CORRECTIVE ACTION

1

Check the cable connections between the ADSL port and the

 

wall jack. The DSL LED on the front panel of the ADSL Router

 

should be on.

2

Check that your VPI, VCI, type of encapsulation and type of

 

multiplexing settings are the same as what you collected from

 

your telephone company and ISP.

3

Restart the ADSL Router. If you still have problems, you may

 

need to verify your VPI, VCI, type of encapsulation and type of

 

multiplexing settings with the telephone company and ISP.

I cannot get a WAN IP address from the ISP.

STEPS

CORRECTIVE ACTION

1

The ISP provides the WAN IP address after authenticating you.

 

Authentication may be through the user name and password,

 

the MAC address or the host name.

2

The username and password apply to PPPoE and PPoA

 

encapsulation only. Make sure that you have entered the correct

 

Service Type, User Name and Password (be sure to use the

 

correct casing).

A.7 Internet Access

I cannot access the Internet.

STEPS

CORRECTIVE ACTION

 

 

1

Make sure the ADSL Router is turned on and connected to the

 

 

network.

 

 

2

If the DSL LED is off, refer to Section A.1.3.

 

 

3

Verify your WAN settings.

 

 

4

Make sure you entered the correct user name and password.

 

 

A02-RA144-W300N

Pag. 86