Atlantis Land A02-RA242-W54 3.6.3.7.2 Dynamic DNS, E.G

WEBSHARE 242W

E.G.

3.6.3.7.2 Dynamic DNS

The Dynamic DNS function lets you alias a dynamic IP address to a static hostname, so if your ISP does not assign you a static IP address you can still use a domain name. This is especially useful for hosting servers via your ADSL connection, so that anyone wishing to connect to you may use your domain name, rather than having to use your dynamic IP address, which changes from time to time. This dynamic IP address is the WAN IP address of the router, which is assigned to you by your ISP.

Click Dynamic DNS to get the below figure then check the “Enable” button to access the Dynamic DNS service.

Contents

USER’S MANUAL Where solutions begin Page Copyright CE Mark Warning FCC Warning CHAPTER Page Page Introduction 1.1 An Overview of the WebShare 242W 1.2 Package Contents 1.3 WebShare 242W Features VLAN: QoS: Domain Name System (DNS) relay: Dynamic Domain Name System (DDNS): PPP over Ethernet (PPPoE): Rich Packet Filtering: Dynamic Host Control Protocol (DHCP) client and server: Static and RIP1/2 Routing: SNTP: SNMP: 1.4 WebShare 242W Wireless Application 2.1 Cautions for using the WebShare 242W Wireless 2.2 The Front LEDs 2.3 The Rear Ports 2.4 Cabling Page Configuration 3.1 Before Configuration 3.2 Connecting the WebShare 242W Wireless 3.3 Configuring PC in Windows For Windows 95/98/ME DNS Configuration Disable DNS “OK” For Windows NT4.0 For Windows Page For Windows XP Page 3.4 Factory Default Settings 3.4.1 Username and Password 3.4.2 LAN and WAN Port Addresses 3.5 Information from the ISP 3.6 Configuring with the Web Browser 3.6.1 STATUS 3.6.1.1 ARP Table/ Wireless Table 3.6.1.2 Routing Table 3.6.1.3DHCP Table 3.6.1.4 System Log 3.6.1.5 Security Log 3.6.2 Quick Start Guide •NAT: Select “Enabled” Optional Setting Subnet Mask: Default Gateway: DNS 3.6.3 CONFIGURATION 3.6.3.1 LAN 3.6.3.1.1 Ethernet 3.6.3.1.2 Wireless 3.6.3.1.3 Wireless Security WPA Pre-SharedKey: WPA Algorithms: WPA Shared Key: Group Key Renewal: Hide ESSID: 3.6.3.1.4 DHCP Server DHCP Relay Agent 3.6.3.2 WAN 3.6.3.2.1 ISP PPPoE(RFC 2516) or PPPoA(RFC 2364) Connect to Demand(PPPoE only): Idle Timeout: MTU: RFC 1483 Routing BRIDGE (PPPoE) 3.6.3.2.2DNS 3.6.3.2.3 ADSL 3.6.3.3 System 3.6.3.3.1 Time Zone 3.6.3.3.2 Remote Access 3.6.3.3.3 Firmware 3.6.3.3.4 Backup/Restore 3.6.3.3.5 Restart 3.6.3.3.6 User Management 3.6.3.4 Firewall 3.6.3.4.1 Packet Filering Add: Edit: Delete: Outgoing / Incoming: Active: Packet Type: Log: Action When Matched: Source IP Address: Source Port: http(OutGoing/Ingoing): POP3 (OutGoing/Ingoing): SMTP (OutGoing/Ingoing): FTP (OutGoing/Ingoing):: 3.6.3.4.2 MAC address Filtering 3.6.3.4.3 Intrusion Detection 3.6.3.4.4 Block Wan Request 3.6.3.4.5 URL Blocking From/To: Block Mode: Keywords Filtering: Domains Filtering: Restrict URL Features 3.6.3.5 QoS Application Time Schedule Direction LAN to WAN: LAN to WAN Controlled Traffic Flow: Packet type ANY: ~TCP ~UDP GRE: Assigned Data rate: Data Ratio Rate Type Fixed (Maximum): Local Machine IPs Remote Machine IPs Local Application Ports Remote Application Ports Schedule Time Connection Diagram ADSL Subscription Rate Example QOS Plan : Example QOS Setup VoIP application FTP Server Application Page HTTP Web Browsing Page 3.6.3.6 Virtual Server Application OutBound Inbound Services Port Number / Protocol 3.6.3.7 Advanced 3.6.3.7.1 Static Routed 3.6.3.7.2 Dynamic DNS 3.6.3.7.3 VLAN 3.6.3.7.4 Device Management Embedded Web Server: Universal Plug and Play (UPnP): Simple Network Management Protocol: SNMP Version: SNMPv2c and SNMPv3 3.6.3.7.5 IGMP 3.6.4 SAVE Config Troubleshooting Problems Starting Up the ADSL Router Problems with the WAN Interface Problems with the LAN Interface Page Traffic Shaping Technical Features Firmware Recovery Support