Atomic 112 owner manual Desktop Modeler in Stereo, Please Note

Desktop Modeler in Stereo
X	^ Z
] Y

\

EFFECTS
LOOP
RETURN		MODEL REACTOR 112
		Atomic Amplifiers LLC.
		Orange CT.
SEND - L
	!CAUTION!	0101010101
SEND - R	FUSE

*PLEASE NOTE!

If you wish to use a pair of Reactors in MONO, simply use the SEND – L output instead of SEND – R.

[

EFFECTS

LOOP

RETURN

SEND - L

SEND - R

!CAUTION!

MODEL REACTOR 112

Atomic Amplifiers LLC.

Orange CT.

FUSE0101010101

XAfter obtaining the proper template load your modeler into the DS-1 that comes provided with your Reactor 112 (see page 8).

[Run a standard shielded 1/4 inch cable from Reactor

#1’s Send R on the rear

*panel to the Return on Reactor #2’s rear panel.

Load the DS-1 into the	Install a blank template onto
Ydocking bay located in the	Zthe Reactor #2’s DS-1.
top of Reactor #1, making	Then load the DS-1 back
sure that the dock locks	into the Reactor.
click into position.	(see page 10)

\If using a foot controller with ]Turn on Reactor #1s

your modeler, connect it as power switch (it should

normal using the connector	light up). Your modeler
access port located on the	should power up at the
rear of the reactor.	same time as the amp.

Turn on Reactor #2s power switch (it	Bring up the levels on your modeler and switch
^should light up).	_ to some of your favorite presets.
	9