Atomic 112 owner manual Installing a Modeler into the DS-1, There is no Need for AN

Installing a Modeler into the DS-1

XScrew the 3 thumbscrews labeled “A”, "B” &”C”, into the corresponding holes located on the bottom of the DS-1.

YAttach the 3 rounded mushroom heads caps to the ends of the locking screws. *

*A set of mushroom heads come shipped with each Reactor 112.

ZPosition the proper docking template on the top of your modeler.

[Insert the docking template along with the modeler into the rear of the DS-1, locating and positioning it in the notch of the template frame.

\Tighten down the thumbscrews until modeler is held securely in place.

]After securing modeler, connect the Input and, Left/Right output connectors. The Input cable is

extra long to accommodate modelers that have their input jacks located on the front. Please note that there is plenty of room to get to foot controller connections etc.

^Use the power cable included with the docking template to connect between your modeler’s power input and the DS-1s power output.

THERE IS NO NEED FOR AN

EXTERNAL POWER SUPPLY. The DS-1 automatically compensates for your modeler’s voltage and polarity.

*The Right Output of the DS-1 connects the modeler directly to the Reactor’s Send - R jack on the effects loop. It keeps the modeler in mono operation unless the Send R is engaged by plugging a cable into it.

6