DLA2/4/6 Speaker Level Audio Router
5. Troubleshooting
Table
Audio
Symptom | Possible Cause | Solution | |
No audio present in a | 1. Source not playing. | Press Play, turn ON, etc. | |
speci c room |
|
| |
|
|
| |
| 2. Room not selected | Select Room on Front | |
|
| Panel or from RF Remote | |
|
|
| |
| 3. Room Output volume | Increase volume. | |
| turned all the way down |
| |
| 4. Speakers in room | a. Test known good | |
| miswired or defective | speaker at back panel | |
|
| speaker connector | |
|
| b. Verify connections | |
|
|
| |
No audio present in any | 1. See above | Perform steps above | |
room |
|
| |
2. Ampli er/Receiver | Turn On Ampli er/Re- | ||
| |||
| turned OFF or down | ceiver or increase | |
|
| volume | |
|
|
| |
| 3. Ampli er or Receiver | Find cause of ampli er’s | |
| in protection mode | protection mode and cor- | |
|
| rect. Miswired speakers | |
|
| most likely cause. Verify | |
|
| that the impedance lev- | |
|
| els of the amp and | |
|
| speaker are not lower | |
|
| than 8 Ohms. | |
|
|
| |
Hum or buzz through | 1. Ground loop | Ensure proper ground- | |
system speakers |
| ing using a three prong | |
|
| grounded AC outlet. | |
|
|
| |
| 2. Receiver/Ampli er | Reduce level | |
| level too high |
| |
|
|
| |
Poor audio quality | 1. Clipping or distortion | Reduce Receiver/Am- | |
|
| pl er level | |
|
|
| |
| 2. Speakers out of phase | Carefully check polarity | |
|
| of each speaker | |
|
|
| |
| 3. Incorrect assignment | Isolate to source or room | |
| of left/right source RCA | and correct | |
| cables or speaker cables |
| |
|
|
|
26 | ©2008 • All rights reserved. |