ATON DLA4, DLA6 Connections, DLA2/4/6, Speaker Cables, Receiver/Amplifier Output, Amplifier Input

DLA2/4/6 Speaker Level Audio Router

3. Connections

AMPLIFIER INPUT

Use 16 AWG stranded copper speaker wire to connect from a speaker level output of an A/V receiver, stereo receiver, or amplifer. Turn power for the output device OFF before making connections.

To make connections:

1.Cut the ends of the wire to length, allowing some free play (about 6 inches of slack) to allow for movement when physically connecting the wire.

2.Using wire strippers, remove 3/8 inch of insulation, then twist the wire to ensure that no stray strands are evident.

3.De ne positive (+) and negative (-) at the ampli er end and the DLA2/4/6 end of the wire run and use the same conductor on each end.

4. Lift up each ip-lock connector until it is locked in the up position.

5.Place the bare lead from each speaker wire from the receiver/ampli er into the holes of the Ampli er Inputs terminal of the DLA2/4/6, maintaining the polarity of each lead (+ to +, - to -).

Note: To avoid damage to the receiver/ampl er, DO NOT allow speaker leads to touch each other.

DLA2/4/6

125Watts per Channel

Max

Speaker

Cables

AMPLIFIER

INPUT

CLASS 2 WIRING

L RL R

+

-

AB

Receiver/Amplifier

Output

Figure 3-1: Receiver/Ampli er Output to DLA2/4/6 Ampli er Input

© 2008 • All rights reserved. 13