AVDINPC
WIRING
Wiring Connections
1. | PS/2 Mouse |
2. | PS/2 Keyboard |
3. | VGA |
4. | LAN |
5. | USB 1/USB 2 |
6. | |
7. | RCA Video |
8. | Printer |
9. | COM Port |
10. | MIC In |
11. | Line Out |
12. | Line In |
13. | AC Adapter (Purchased Separately) – Only use an AC adapter with the |
| following specifications: Output – 12V, 4.3A; Input – |
| 60Hz; Center pin (+) positive |
14. | Car Power Input |
15. | Power Supply |
16. | ILLUMINATION WIRE (yellow) |
17. | ACC POWER WIRE (red) – Connect to a +12 volt circuit that is only live |
| when the ignition is on. The best connection point is at the car’s fuse |
| block at the “RADIO” or “ACCESSORY” identified terminals. |
18. | CONSTANT POWER WIRE (yellow) – Connect the 12V PLUS constant |
| power wire to a live 12 volt wire in the vehicle. Before making a |
| connection, check that the wire you intend to connect it to is always live, |
| even when the car’s ignition is turned off. If a live wire is not found, route |
| the wire to the car’s fuse block and connect it to a live circuit there. |
19. | GROUND WIRE (black) – Securely fasten the Ground wire to a grounded |
| metal part of the car’s chassis. If you cannot find an existing bolt or screw |
| to fasten it to, drill a hole in the metal and secure it with a screw. To |
| ensure a good ground, remove any paint or grease from areas where the |
4 | 8 | 11 | 12 | 13 |
1
14
2
3 | 5 | 6 | 7 | 9 | 10 |
Black
19
Red
17
Yellow
18
FUSE BOX
Red
20
+
Red
BATTERY
wire will contact the surface. |
20. INLINE FUSE (red) – When running the red ACC Power wire directly to |
the battery, the inline fuse MUST be connected between the unit and the |
battery (within 18” of the battery). If the ACC Power wire is connected to |
the fuse block, the inline fuse is not required. |
16
Yellow
15
Figure 3: Wiring Connections
5
