17

Troubleshooting

Problem

Possible Cause

 

 

 

Burners will not light using Burners not assembled correctly the ignitor

Not pressing igniter in enough for spark.

No spark - out of place, loose, or broken.

Solution

See re-assembly after cleaning in

“Care and Maintenance.”

Push Regulator Knob in and turn counterclockwise to the “High” position. Depress the Igniter Button until a loud click is heard. Repeat until the Burner lights.

1.Electrode tip is bent (making too large or small of a gap between the Electrode and burner). Bend electrode tip back to a 3/16” gap to burner. (Page 10)

2.Tighten Electrode mounting screws.

3.Replace Igniter Wire/Electrode assembly.

(Call the Customer Service Department)

LP gas cylinder is empty

Purchase new 1 lb. LP Gas Cylinder.

LP cylinder is not fully attached

Tighten cylinder by hand. Do not use tools.

to regulator

 

Obstructions in Burners

See “How to Clean Burners” in Care and Maintenance.

Wet Electrodes and Burners

Allow electrode to air dry, dry with clean cloth or blow dryer.

Wire loose or disconnected.

Reconnect the wire.

Wire shorting (sparking

Replace Igniter Wire/Electrode assembly.

between Igniter and Electrode)

(Call the Customer Service Department)

Burners will not light using Burners not assembled correctly. See re-assembly after cleaning in Care and Maintenance. a match

LP Gas Cylinder is empty.

Purchase new 1 lb. LP Gas Cylinder.

LP cylinder is not fully attached

Tighten cylinder by hand. Do not use tools.

to regulator.

 

Obstructions in Burners.

See “How to Clean Burners” in Care and Maintenance.

Low flame or low heat

Flames blow out

Flare up

Persistent grease fire

LP-gas in LP Gas Cylinder is low.

High or gusting winds.

Gas in LP cylinder is low.

Grease build-up.

Excessive fat in meat.

Grease trapped around burner system.

Purchase new 1 lb. LP Gas Cylinder.

Turn front of grill away from wind or increase flame height.

Purchase new 1 lb. LP Gas Cylinder.

Clean grill.

Trim fat from meat before grilling.

Turn Regulator Knob “Off” then remove the LP Gas Cylin- der. Open Hood carefully and let fire burn out. After the grill cools, remove and clean all parts.

If your problem is not resolved from the information provided above,

please visit our website @ www.aussiegrills.com or call Customer Service at 1-800-251-7558.

If you need a replacement part under warranty, a proof of purchase will be necessary.

Page 17
Image 17
Aussie 6T01U00SS1 user manual Troubleshooting, Problem Possible Cause, See How to Clean Burners in Care and Maintenance