Aussie 6T01U00SS1 How to Perform A Leak Test - FIRST TIME USE and as recommended on previous page

Supplies Needed for a Leak Test:

• Clean paint brush • Water • Dish washing liquid • Empty clean bowl or can for solution

1. Make sure the regulator knob is turned to the “Off” position and verify that th e LP Gas Cylinder is tightened

securely to the regulator.

2. Mix one part of water with one part of dish washing liquid.

3. Brush mix on Regulator, Propane Cylinder and connection as indicated by the heavy arrows in th e figure below

. If “growing” bubbles appear, there is a gas leak.

a. If leak appears at the regulator/cylinder connection, repeat cylinder installation proc edure, but do not over-

tighten. (NOTE: Only hand tighten) Repeat Leak Test.

b. If the leak is coming from the Gas Cylinder or if the leak cannot be stopped, remove the cy linder and DO NOT

USE THE GRILL. Call Customer Ser vice at 1-800-251-7558. Be sure to have the grill model number and

serial number printed on the label, located on the inside of the rear leg. If you need a replaceme nt part

under warranty, a proof of purchas e will be necessary.

How to Perform A Leak Test - “FIRST TIME USE” and as recommended on previous page