ZC Kit – Large Pellet Insert
(99200149)
Insert Preparation and Placement
•Place the extending hopper into its highest position (see the manual for details). This increases the pellet capacity of the heater.
•Install the surround panels onto the insert and slide it into place. The surround panels must maintain a 3/8” gap from the enclosure opening (the
•After the insert is in place, attach the vent starter section to the insert (it is attached with a latch – make sure the gasket is correctly positioned).
•The leveling bolts may be used to level the insert.
•We recommend the use of the Insert Wiring Kit when installing this kit (SKU 97200315). This kit allows for the power cord to be
Rear Vent Shield (used only on inserts | Vent Clearances (make sure |
venting directly to the rear - note how it is | all vent maintains 3” clearance |
slid back until it contacts the wall thimble) | to any combustible) |
|
|
12”
House Shield
(prevents soot discoloration)
HIGHLY RECOMMENDED
Outside Air
Enclosure Height |
(measure from top of |
floor protection) |
Floor Protection |
Connection | Wall Thimble (note 3” clearance between | Vent Latch (used to connect and | |
| |||
(recommended) |
| ||
vent and combustibles) | disconnect the vent ) | ||
| |||
|
|
Page 8 of 8 | 10/9/06 | © Travis Industries, Inc. |