Avanti BD6000 Important Safety Instructions, Installation Instructions, ?Warning?

IMPORTANT SAFETY INSTRUCTIONS

?WARNING?

To reduce the risk of fire, electrical shock, or injury when using your Beer Dispenser, follow these basic precautions:

?Read all instructions before using the unit.

?DANGER or WARNING: Risk of child entrapment.

Child entrapment and suffocation are not problems of the past. Junked or abandoned appliances are still dangerous . . . even if they will “just sit in the garage a few days”.

?Before you throw away your old unit: Take off the door. Leave the shelves in place so that children may not easily climb inside.

?Never allow children to operate, play with, or crawl inside the unit.

?Never clean unit parts with flammable fluids. The fumes can create a fire hazard or explosion.

?Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or any other unit. The fumes can create a fire hazard or explosion.

-Save these instructions-

INSTALLATION INSTRUCTIONS

?Before Using Your Beer Dispenser

?Remove the exterior and interior packing.

?Check to be sure you have all of the following parts:

?	1 Instruction manual			?	1	Pull Handle (Beer Tower Faucet)
? 1 Safety Guard Rail				?	1 Metal Wrench
? 1 Drip Tray (2 Pieces)				?	4	Plugs (For Guard Rail Holes )
?	1	CO2 Cylinder Holder		?	1	Metal Plate for Cabinet Bottom
?	1	CO2	Regulator (Box)	?	2	Steel Wire Shelves
?	1	CO2	Empty Cylinder(Box)	?	1	Steel Clamp for Red Hose
?	1	CO2	Air Line Hose (Red)	?	1	Beer Tower Top Plastic Cover
?	2	CO2	Hose Connectors	?	1	DVD Instruction
?	1	Beer Keg Coupler (Box)		?	4	Castors with Lock

? 1 Beer Tower Assembly

?Before connecting the Beer Dispenser to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.

?Clean the interior surface with lukewarm water using a soft cloth.

?Installation of Your Beer Dispenser

?This appliance is designed to be free standing only, and should not be recessed or built-in.

?Place your Beer Dispenser on a floor that is strong enough to support the Beer Dispenser when it is fully loaded.

?Allow 3 inches of space between the back and sides of the Beer Dispenser, which allows the proper air circulation to cool the compressor and condenser.

?Locate the Beer Dispenser away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the Beer Dispenser not to perform properly.

?Avoid locating the Beer Dispenser in moist areas.

?Plug the Beer Dispenser into an exclusive, properly installed-grounded wall outlet. Do not

9