Configure H.323 video endpoints on Communication Manager 6.0
Table 8: Configuring Polycom RMX Series Video conferencing on Bridge Platform
4 | Use the change | |
| Step 2) to add members to the trunk group. The number of members depends on the | |
| maximum simultaneous calls an RMX supports. | |
|
| |
5 | Use the change | |
| to use) to create a route pattern that points to the | |
6 | Install the Polycom system and connect it to your network. | |
|
| |
7 | Upgrade the Polycom system software (if necessary). | |
|
| |
8 | Access the Polycom home page for the unit. | |
|
| |
9 | From the Setup menu, select the System Configuration tab. | |
|
| |
10 | Under the MCMS_PARAMETERS_USER, configure the following settings: | |
| ● MCU_DISPLAY_NAME: POLYCOM | |
| ● ENABLE_AUTO_EXTENSION: YES | |
| ● | NUMERIC_CONF_ID_LEN: 5 |
| ● CP_REGARD_TO_INCOMING_SETUP_RATE: NO | |
| ● | NUMERIC_CONF_ID_MAX_LEN: 8 |
| ● | NUMERIC_CONF_ID_MIN_LEN: 4 |
| ● TERMINATE_CONF_AFTER_CHAIR_DROP: NO | |
| ● | H323_FREE_VIDEO_RESOURCES: NO |
|
| |
11 | Under CS_MODULE_PARAMETERS, add:H245_TUNNELING: YES | |
|
| |
12 | Create an H.323 service, and enter the CLAN or PROCR IP address of the | |
| Communication Manager system as the primary gatekeeper. Confirm through a status | |
| signaling group that the RMX has registered. | |
|
| |
13 | Create a meeting room to use a test direct dial conference ID. | |
|
|
|
AVTS R 6.0 Quick Setup | For feedback, use document@avaya.com | August 2010 18 |
