Avaya 16-300310 manual Configuring Polycom Endpoints, Add Users/stations to Polycom endpoints

Configure H.323 video endpoints on Communication Manager 6.0

Configuring Polycom Endpoints

Use this procedure to configure the Video calling facility for all Polycom endpoint users.

Table 6: Configuring Polycom Endpoints

1Enter display system-parameters customer-options to verify the Maximum Video Capable Stations (page 2 of screen). This number is provided by the RFA license file. The Maximum Video Capable Stations was determined using the following criteria:

●Each V500/700 system is considered to be one station

●Each single-point VSX/HDX system is considered to be one station

●Each VSX multpoint system can be three to six stations

Each HDX system can be three stations for multipoint plus four and seven for multipoint plus eight multipoint licensed options for the HDX9004. The HDX9002 only has multipoint plus 4 as an option.

2Enter change cos to set Priority Video Calling (page 2 of screen) for the appropriate COS levels.

3Enter add station to add a station for the Polycom system. Set the following parameters:

●Type :H.323

●Security Code : the “pin” you will administer for the VSX, HDX, V500 or V700 system

●IP Video : y

●If you want this station to be able to make priority video calls, make sure you select a COS level that has Priority Video Calling enabled. (See Step 2)

●On page 2 of the screen, set Direct IP-IP Audio Connections to y

Note:

You can create an alias for VSX/HDX stations.

Add Users/stations to Polycom endpoints

Use this procedure to add users/stations to the Polycom endpoints.

AVTS R 6.0 Quick Setup For feedback, use document@avaya.com August 2010 15