IP401 Compact Office Platform IP401 Compact Office - Front View - Page 11
IP401 Compact Office - Front View DT Ports 1-
4
Green LEDs - Terminal connected
Yellow LEDs – Status of ISDN/WAN links
Unit Status LED
Red = Alive but not init iated
Green = Running OK
LAN Port
4
(Cascade Port)
Phone Ports 1 -
4
(POTS)
LAN Ports 1-
8
Solid Green LED - LAN O
K
Flashing Green - LAN OK and activ
e
Yellow LED on – 100Mbps operatio
n
Yellow LED 0ff - 10Mbps operatio
n
Cascade Switch
(for Port 4)
Note: The IP Compact Office DT4 is shown above. The IP Compact Office DT2 does not have
the top row (labeled 3 DT 4, 3 POT 4, 5 LAN 6 and 7 LAN 8) of RJ45 ports fitted.
Port connections
• DT Ports
DT ports are used for connection to Avaya 2000 series telephones (see page 5) and support
either A-Law or µ-Law PCM encoding (default A-Law). Using DT Line Cords (see page 56) and
standard structured wiring, these RJ45 ports can be extended to the required telephone location.
In addition, converters can be used to provide BT New Plan sockets (431A/631A) if required (see
page 65). When telephones are equipped with line cords that terminate in RJ11 plugs, then pin-
to-pin RJ11/RJ45 adapters should be used.
• Plain Ordinary Telephone (POT) Ports
These ports are used for connection to standard analog telephones, fax machines and modems.
Using standard structured wiring, these RJ45 ports can be extended to the required telephone
location. Converters can be used to provide BT New Plan sockets (431A/631A) if required (see
page 65). When telephones are equipped with line cords that terminate in RJ11 plugs, then pin-
to-pin RJ11/RJ45 adapters should be used.
• LAN Ports
The auto-negotiating 10/100 BaseT LAN hub ports are used for PC and server connectivity. They
can also be used to connect to IP telephones (Avaya 4600 IP series).
LAN ports allow information relating to incoming and outgoing telephone calls to be forwarded to
PC based applications. They also provide access to the router functionality/configuration of the
IP401 Compact Office platform for both data and Voice over IP (VoIP) calls. The auto-negotiating
10/100 BaseT LAN hub ports support a single MAC address only (printed on base of unit).
Where more than eight LAN connections are required, the fourth LAN port can be used for
cascading to other hubs. The Cascade pushbutton to the right of this port is used to set the
mode. When the Cascade switch is in the out position the port can be connected to another hub
without the need for a crossover cable, i.e. the port is an MDI type port. When the Cascade
switch is in the in position the port can be connected directly to a PC.
Cables
IP401 Compact Office 2 is supplied with one red ISDN cable. The Compact Office 4 is supplied with
two red ISDN cables. For Port Pinouts and Cables, refer to pages 51 and 55 respectively.
IP Office Installation Manual IP401 Compact Office Platform - Page 11
40DHB0002USCL – Issue 7 (09/25/2002) IP401 Compact Office - Front View