Page 6 - Lithium Batteries Safety and Homologation Statements
Safety and Homologation Statements CE Mark
The "CE" mark affixed to this equipment means that the unit complies with the 1999/5/EC (R&TTE),
89/336/EEC (EMC) and 72/23EEC (LVD) Directives
Declaration of Conformity
The Declaration of Conformity (DoC) for the IP400 Office products is contained with in the CD
accompanying the products.
This warning symbol may be found on the base of IP401, IP403, IP416 and IP412 units.
Refer to page 7 for information concerning which Trunk Interface module variants can be
fitted in which country
WARNING
The Avaya IP400 Office units are intended to be installed by 'Service Personnel' and it is the
responsibility of the Service Personnel to ensure that all subsidiary interconnected equipment is
wired correctly and also meet the safety requirements of IEC60950 or UL60950 where applicable.
Lithium Batteries
A lithium battery is fitted to the real time clock on the IP401/403/406 and IP412 mother boards.
WARNING
The Lithium battery must be replaced by Avaya personnel or authorized representatives. There
is a danger of explosion if the battery is incorrectly replaced. Replace only with the same or
equivalent type recommended by the manufacturer. Dispose of used batteries according to the
manufacturer's instructions.
Electromagnetic Interference Information
Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which case
the user will be required to correct the interference at his or her own expense.
Canadian Department of Communications (DOC)
''NOTICE: This equipment meets the applicable Industry Canada Terminal Equipment Technical
Specifications. This is confirmed by the registration number. The abbreviation, IC, before the
registration number signifies that registration was performed based on a Declaration of Conformity
indicating that Industry Canada technical specifications were met. It does not imply that Industry
Canada approved the equipment.”
89/336/ EEC (EMC Directive) CISPR 22:1993 including A1 + A2,
AS/NZ 3548:1995 (ROW)
WARNING
IP401 Compact Office, IP403, IP406, IP412 and all Expansion Modules are Class A products. In a
domestic environment, IP401 Compact Office, IP403, IP406, IP412 and all Expansion Modules may
cause radio interference in which case the user may be requested to take adequate measures.
Page 6 - Safety and Homologation Statements IP Office Installation Manual
Lithium Batteries 40DHB0002USCL – Issue 7 (09/25/2002)