PARTNER® Advanced Communications System
38
PARTNER® ACS 1600 DSL Module Planning Checklist
Required Information Notes Sample values Enter values for current installation
5. VoIP settings Obtain these settings if your SDSL provider uses VoIP with the Lucent PathStar o r other VoI P vo ice ga teway. Th ese s ettings are in
addition to the required ATM or Frame Rela y settings.
IP address of Notified
Entity1 IP address of the VoIP gateway 192.168.32.2
IP address for MGCP
signaling1Media Gateway Control Protocol. This is the IP address
of the voice PVC on the 1600 DSL; used for signal
control.
192.168.32.3
TOS byte value1Leave at 7 unless specified by SDSL provider. 1-7
IP address for RTP
signaling1Real Time Protocol. This is also the IP address of the
voice PVC on the 1600 DSL; used for controlling the
voice PVC.
192.168.32.3
TOS byte value1Leave at 7 unless specified by SDSL provider. 1-7
6. IP Router Settings IP router settings apply to the data PVC only.
SDSL (WAN) port
address2The public address that external routers use to find the
1600 DSL module. Select the data PVC when
configuring.
192.168.32.40
WAN port subnet mask2Required regardless of transport protocol. 255.255.255.0
Normal/High priority2Sets the priority of the data port; le ave at norm al for da ta
PVC; set to high if using MGCP voice (VoIP). Normal/High
Default route (gateway)
IP address2IP address of the ISP. The address to which the router
sends packets it otherwise does not know how to route.
NOTE: The netmask for the default route does not
require a manual setting. The netmask is determined
automatically.
192.168.32.2
10/100BaseT Ethernet
address3Address for the LAN port of the 1600 DSL module. 192.168.32.2
1. Obtained from SDSL provider
2. Obtained from ISP
3. Obtained from customer/LAN VAR