12AutoView 424 Installer/User Guide

To install an AutoView 424 switch:

1.Power down all computers that will be part of your AutoView 424 system.

2.Plug your VGA monitor cable into the port labeled on the back of your AutoView 424. For Sun support, plug your Sun connector into the port

labeled SUN and for PS/2 peripherals, plug your PS/2 keyboard cable and

your PS/2 mouse cable into the ports labeled and respectively.

NOTE: A PS/2 keyboard will not function if a Sun keyboard is attached. However, you may use a PS/2 mouse with a Sun keyboard.

3.Locate the input cable appropriate to the computer you are connecting. AutoView 424 cable types are identified below. Plug this cable into any numbered channel port on the rear of the AutoView 424. The other end of the input cable will have up to three connectors depending on type. Plug these connectors into the matching ports on your computer.

AutoView 424 Cable Types

Cable

Description

Length

CIFCM-4

PS/2 only/VGA

4 ft

CIFCM-8

PS/2 only/VGA

8 ft

CIFCM-15

PS/2 only/VGA

15 ft

CIFCM-30

PS/2 only/VGA

30 ft

 

 

 

CUSBM-4

USB/VGA

4 ft

CUSBM-8

USB/VGA

8 ft

CUSBM-12

USB/VGA

12 ft

 

 

 

CWSNM-4

SUN Kbd/Mouse 13W3

4 ft

CWSNM-8

SUN Kbd/Mouse 13W3

8 ft

CWSNM-15

SUN Kbd/Mouse 13W3

15 ft

CWSNM-30

SUN Kbd/Mouse 13W3

30 ft

 

 

 

CVSNM-4

SUN Kbd/Mouse VGA

4 ft

CVSNM-8

SUN Kbd/Mouse VGA

8 ft

CVSNM-15

SUN Kbd/Mouse VGA

15 ft

CVSNM-30

SUN Kbd/Mouse VGA

30 ft

 

 

 

4.Locate your next input cable. Repeat step 3 until all computers are properly attached to the AutoView 424.

5.Locate the power cord that came with your AutoView 424 unit and plug it into the IEC power connector on the AutoView 424. Make sure that the power switch is off, then plug the other end of the power cord into an appropriate AC wall outlet. This outlet must be near the equipment and easily accessible to allow for unplugging prior to any servicing of the unit.

6.Power up your AutoView 424 unit first, then power up all attached computers.