Axis Communications 241S user manual Axis 241Q Front Panel, Network

AXIS 241Q/241S - Product Description 7

AXIS 241Q Front Panel

Indicators - After completion of the startup and self-test routines, the multi-colored Network, Status, Power Indicators flash as follows:

	Amber	Flashes for activity on a 10 Mbit/s network
Network	Green	Flashes for activity on a 100 Mbit/s network
	Red	Flashes rapid red for hardware error, together with the Status indicator
	None	No connection
	Green	Normal operation
Status
	Amber	Flashes during reset to factory default or at firmware upgrade
	Red	Flashes rapid red for a hardware error, together with the Network indicator
Power	Green	Normal operation
	Amber	Flashes green/amber during upgrade

DIP Switches - A corresponding line termination switch for each of the supported video inputs. All units are shipped with the line termination enabled for each supported video input; that is, with the DIP switches set in the down-position.

Note: If the AXIS 241Q is to be connected in parallel with other equipment, disable the input termination by turn- ing the corresponding DIP switch to the up-position (OFF). Failure to do so may cause reduced image quality.

Control Button - Press this button to restore the factory default settings, as described in Resetting to the Factory Default Settings, on page 47, or to install using AXIS Internet Dynamic DNS Service (page 15).

Video Inputs - Accommodates up to 4 separate video sources (VIDEO 1 - VIDEO 4) simultaneously. Each supported video input is connected using a coax/BNC connector. Physical connections made using e.g. 75 Ohm coax video cable have a recommended maximum length of 800 feet (250 meters).