Axis Communications P1347-E, P1343-E, P13-E manual Unit connectors, Set the IP address with ARP/Ping

Page 22 AXIS P13-E Network Camera Series Installation Guide

Set the IP address with ARP/Ping

1.Acquire a free static IP address on the same network segment your computer is connected to.

2.Locate the serial number (S/N) on the product label on the camera.

3.Open a command prompt on your computer and enter the following commands:

Windows syntax:	Windows	example:
arp -s <IP Address> <Serial Number>	arp -s 192.168.0.125 00-40-8c-18-10-00
ping -l 408 -t <IP Address>	ping -l	408 -t 192.168.0.125
UNIX/Linux/Mac syntax:	UNIX/Linux/Mac example:
arp -s <IP Address> <Serial Number> temp	arp -s 192.168.0.125 00:40:8c:18:10:00 temp
ping -s 408 <IP Address>	ping -s	408 192.168.0.125

4.Check that the network cable is connected to the camera and then start/restart the camera, by disconnecting and reconnecting power.

5.Close the command prompt when you see ‘Reply from 192.168.0.125:...’ or similar.

6.In your browser, type in http://<IP address> in the Location/Address field and press Enter on your keyboard.

Notes:

•To open a command prompt in Windows: from the Start menu, select Run... and type cmd. Click OK.

•To use the ARP command in Windows Vista, right-click the command prompt icon and select Run as administrator.

•To use the ARP command on a Mac OS X, use the Terminal utility in Application > Utilities.

Unit connectors

Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet. Using shielded cables is recommended.

Power connector - 2-pin connector block used for power input (not used).
Audio in - 3.5 mm input for a mono microphone, or a line-in mono signal (left
channel is used from a stereo signal).
Audio out - Audio output (line level) that can be connected to a public address (PA)	1	2
system or an active speaker with a built-in amplifier. A pair of headphones can also

be attached. A stereo connector must be used for the audio out.