Axis Communications P1343-E, P1347-E, P13-E manual Route the network cable through the cable hole

AXIS P13-E Network Camera Series Installation Guide Page 9

Route the network cable through the cable hole

1. Loosen the cable cover screws; detach the cable cover from the bottom cover.

Cableg land

Gasket

Plug (discard)

Cap

2.Remove the cap, the plug and the gasket from the cable gland that is to be used.

3.Route the network cable through the cap.

4.Slide the network cable through the slit on the gasket to attach the gasket to the network cable. See Unit connectors, on page 22 for information on network cable requirements.

5.Route the network cable through the cable gland.

6.Press the gasket into the cable gland and screw the cap on firmly.

Note:

Using any other than the provided cable gland may cause water to seep in and damage the product. Cables must have a diameter of 4.0 mm - 5.5 mm.

ENGLISH