SECTION - 4

OPERATING INSTRUCTIONS

4.1TURN ON SETTING PROCEDURE :

The following procedure describes the use of controls and indicators for Constant Voltage and Constant Current Mode of Operation.

CONSTANT VOLTAGE (CV) MODE :

a.Set ‘POWER ON’ Switch & keep the OUTPUT ON/OFF switch to OFF

position ( ).

b.Press LIMIT switch and adjust the VOLTAGE controls till the desired voltage is

indicated on Voltmeter ( ).

c.Press OUTPUT switch to ON position and observe that CV LED lights ( )

CONSTANT CURRENT VOLTAGE (CC) MODE :

 

 

a. Turn off the suppy. Short circuit the output terminals

of the power supply

& turn on the supply.

 

 

b. Keep the OUTPUT ON/OFF switch in the OFF position

(

).

c.Press LIMIT switch and adjust the CURRENT controls till the desired current is

indicated on Ammeter ( ).

d.Press OUTPUT switch ON position and observe that CC LED lights ( ).

e.Remove the short circuit.

4.2SET LIMIT CONTROL (VOLTAGE AND CURRENT) :

To preset the output Voltage and Current, proceed as follows :

a.Set the OUTPUT switch to OFF position ( ) ( Release Position ).

b.Press the LIMIT switch and adjust the desired output voltage with the

VOLTAGE control potentiometers ( ).

c.Release the LIMIT switch, set the OUTPUT switch to ON position and check

the output voltage on the voltmeter ( ).

d.Set the OUTPUT switch to OFF position ( ).

e.Press the LIMIT switch and adjust the desired output current limit with the

CURRENT control potentiometers ( ).

f.Release the LIMIT switch, set the OUTPUT switch to ON position and check

the output current on the ammeter ( ).

g.Set the OUTPUT switch to OFF position ( ).

h.Connect the load to the Output terminals and set the OUTPUT switch to ON

position ( ).

4.3LOAD CONNECTIONS :

The load should be connected to the power supply output terminals using separate pairs of connecting wires. This will minimize mutual coupling effects between loads and will retain full advantage of the low output impedance of the power supply. Each pair of connecting wires should be as short as possible and twisted or shielded to reduce noise pick up. (If a shielded pair is used, connect one end of the shield to ground and leave the other end unconnected).

5

Page 8
Image 8
B&K 1794 instruction manual Section Operating Instructions