Instruction 24-94483-8
Initial Setup
3.9 Date Setup
The date is stored in the format: MM/DD/YY. Its
value is part of the date and time stamp that is
saved along with each combustion test record.
Set the analyzer’s internal clock to the current
date as follows:
1. Display the MAIN MENU by pressing the
MENU (F2) button. If necessary, press ESC
until MENU appears above F2.
2. Use the buttons to highlight SETUP,
and then press ENT to display the SETUP
MENU.
3. Use the buttons to highlight DATE, and
then press ENT to display the DATE MENU.
4. First use the buttons to move the cursor
across the screen until it is over the digit to
be changed, and then press the buttons
until the desired value is displayed.
5. Repeat Step 4 until the values for month, day,
and year have been set.
6. Press ENT to save the displayed date values
and re-display the SETUP MENU, or press
ESC to abort this procedure and retain the
old date values.
Note: The Date and Time real time clock is powered by the main bat-
teries and is maintained by a supercap on the Main PCB for approxi-
mately 1-2 days in the absence of batteries. The supercap is intended
to maintain the real time clock when the batteries are changed when
exhausted. If the batteries are removed for extended periods of time
such as when the PCA2 is not in use (off-season storage), simply reset
the time and date after fresh batteries are installed when it is placed
back in service.
MAIN MENU
FUEL
PRESSURE
MEMORY
SETUP
CALIBRATION
DIAGNOSTICS
STATUS
F1 F2 F3
MENU
SETUP MENU
TEMP UNITS
PRESSURE UNITS
POLLUTION UNITS
DATE
TIME
O2 REF
PRINT PRESSURE
(more)
MENU
F1 F2 F3
DATE MENU
DATE 05/26/06
05/26/06 09:25:30 AM
MENU
F1 F2 F3