![](/images/new-backgrounds/1085384/8538433x1.webp)
Figure 46
Figure 47
Figure 48
Figure 49
12.For CA70 units, secure fan blower motor bracket with the four phillips screws. Reattach thermostat probe clips with two flathead screws.
**NOTE: DO NOT kink or bend the copper probe or tubing.
13.For CA43 units, reattach thermostat probe clips with two flathead screws.
**NOTE: DO NOT kink or bend the copper probe or tubing. Secure fan blower motor bracket with the four flathead screws.
14.Reconnect existing wires to new motor wires. It is not important which new wire is matched with which existing wire group.
15.Replace fan blower motor housing cover, carefully guiding the wires to prevent damage.
16.Replace fan blower motor assembly cover with two front and two rear flathead screws.
17.Replace top mounted heating module (section
6-1l. Replacing heating element.
Required: Medium (6") flathead screwdriver, Medium (6") phillips screwdriver, Crescent wrench, General Electric 1209 caulking
1.Remove top mounted heating module as found in section
2.Remove four screws that secure the air deflector housing (on your right as you are facing the front of heating module) to the module with a medium (6”) flathead screwdriver.(Fig. 47)
3.Gently lift the air deflector housing to access the nuts connecting wires to the heating element. Remove those nuts and washers to free the wires. (Fig. 48)
4.Remove air deflector housing" and place on a clean work area.
5.Remove four screws securing the heating element brackets to the ceramic insulators with a medium (6") flathead screwdriver. (Fig. 49)
6.Slide brackets off the old element and discard the old element.
7.Slide brackets (large one first) over the connector end of the new heating element. (Fig. 50)
8.Reconnect heating element brackets to the ceramic insulators with the four phillips screws. Do not over tighten.
9.Return air deflector housing to the heating module and reconnect wiring (it is not important which way you match the wires to the new element). (Fig. 51)
10.Caulk openings where the heating element enters the air deflector housing with GE 1209 caulking. (Fig. 52)
11.Reconnect air deflector housing to heating module with the four flathead screws.
12.Replace top mounted heating module (section
Figure 50
Figure1751
Figure 52